Dewert Megamat MC1 47047 Compatible
Dewert Megamat MC1 47047
This compatible electric recliner motor replaces the now obsolete Megamat MC1 47047. The Dewert Megamat comes 500N / 500N which = 50kg and a speed of 36mm/s. Our unit comes 1,000N/800N = 100 / 80kg with a speed of 20mm/s. The faster they go, the less weight they can push / pull. We believe our specifications are a good balance for the average weighted person. Reliability over speed. Scroll down or swipe up for more info
This compatible Dewert Megamat MC1 47047 actuator is found in the standard electric recliner and comes with a new power supply unit, kit form and you use your existing two button switch.
Removing & Fitting A Actuator
1 Place a drop sheet or old towels around the recliner.
2 Turn off and remove the power supply plug from the mains.
3 Gently turn the recliner over onto its side or on its back. Remember correct lifting methods.
4 Locate the component and its lead. Follow the lead along to the plug ends remembering where it runs.
5 Using a pair of side cutters, snip the cable ties that are retaining the lead to the frame.
6 Loctate the two mounting pins and clips that hold the motor to the frame. Remove the wire retaining clips from the pins using a pair of pointy noise pliars. Hold the motor and remove the pins.
7 Place the new motor assmebly into position. Replace the pins through the mounting holes and attach the wire clips.
8 Plug in all leads and run them along the frame. Check that all leads are out of the way of moving parts. Cable tie the leads back to the frame.
9 Turn the recliner back over to normal seating position
10 Plug the main power supply back into the wall.
11 Test the new component. Operate the lift chair recliner to its fullest position and check that all the leads are clear and not stretched.
12 Return the lift chair to its normal seating position.
DO NOT exceed more then 2 mins operating time at anyone time.
If you do exceed this time, wait 20 mins before using again.
Universal Actuator Measurments
The universal actuators have an overall length of 425mm and a stroke of 250mm. This is industry standard and also has then "0l" power lead plus the 5 pin plug control plug. This overall measurement is from the center of the clevis pin mounting hole to the center of the mounting nut on the opposite end. Please refer to our Data Spec Sheet . This kit also comes with a 1 year warranty.
250mm Actuator Specifications
- Input Voltage:
- 24V DC
- Max Load Capacity:
- Push - 1,000 (100kgs), Pull - 800N (100kgs)
- Max Speed:
- Std Stroke:
- MIN Install:
- Limit Switch:
- Type Of Duty:
- S2 - 10mins
- Protection Class:
- CE / EMC+LVD
- Power Wire Plug:
- Standard 0I Plug
- Hand Control Plug:
- Female 5 Pin Plug
This Actuator Kit Contains
- x 1
- 0I Extension Cable:
- x 1
- Power Supply:
- x 1
- Power Cable:
- x 1