Kaidi KDYJT006-15 Compatible Actuator
Kaidi KDYJT006-15 compatible actuator. This actuator comes in the standard industry length 285mm minimum install length, has a stroke length of 117mm and is commonly found in chaise lounges.
We also provide a 1 year warranty on ALL our electric recliner parts.
Designed by CouchGuard® - Powered by Okin
CouchGuard® is an Australian Owned Company
$165.00, save $15.00
CouchGuard® compatible actuators, such as the Kaidi KDYJT006-15 are designed by CouchGuard®, made and powered by Okin.
Okin is the industry leader in motion seating since 1975. It has operations in 6 continents, 56 branches in over 60 countries.
It just makes sense to team up with a global partner so we can offer the best OEM and compatible components right here in Australia.
Removing & Fitting A Actuator
1 Place a drop sheet or old towels around the recliner.
2 Turn off and remove the power supply plug from the mains.
3 Gently turn the recliner over onto its side or on its back. Remember correct lifting methods.
4 Locate the component and its lead. Follow the lead along to the plug ends remembering where it runs.
5 Using a pair of side cutters, snip the cable ties that are retaining the lead to the frame.
6 Loctate the two mounting pins and clips that hold the motor to the frame. Remove the wire retaining clips from the pins using a pair of pointy noise pliars. Hold the motor and remove the pins.
7 Place the new motor assmebly into position. Replace the pins through the mounting holes and attach the wire clips.
8 Plug in all leads and run them along the frame. Check that all leads are out of the way of moving parts. Cable tie the leads back to the frame.
9 Turn the recliner back over to normal seating position
10 Plug the main power supply back into the wall.
11 Test the new component. Operate the lift chair recliner to its fullest position and check that all the leads are clear and not stretched.
12 Return the lift chair to its normal seating position.
DO NOT exceed more then 2 mins operating time at anyone time.
If you do exceed this time, wait 20 mins before using again.
Universal Actuator Measurments
The universal actuators have an overall length of 285mm and a stroke of 117mm. This is industry standard and also has then "0I" power lead plus the 5 pin plug control plug. This overall measurement is from the center of the clevis pin mounting hole to the center of the mounting nut on the opposite end. Please refer to our Data Spec Sheet. The stroke is the distance the white plastic guide travels . This kit also comes with a 1 year warranty.
240mm Actuator Specifications
- Input Voltage:
- 24V DC
- Max Load Capacity:
- 1500N (150kgs)
- Max Speed:
- Std Stroke:
- MIN Install:
- Limit Switch:
- Max Duty Cycle:
- 2min on - 18mins OFF (10%)
- Protection Class:
- CE / EMC+LVD
- Power Wire Plug:
- Standard 0I Plug
- Hand Control Plug:
- Female 5 Pin Plug