Compatible Okin Refined-R Motor
Okin Refined-R Recliner Motor
CouchGuard® compatible Okin Refined-R Motor. The actuator as it is known, comes in the standard industry length 240mm and is also available as a kit which contains the actuator power supply, extension cable and the figure 8 power cable. Swipe up or scroll down to discover more
We also provide a 1 year warranty on ALL our electric recliner parts. Australian Owned Company. Please also note this is not a lift chair actuator.
Select YOUR option from the drop down menu here:
|1 items||$165.00 / each|
|2 or more items||$156.75 / each||save 5%|
240mm Stroke Actuator - There are many Refined-R models so please measure carefully. Click or Tap on the "Data Spec Sheet" tab above for measurements.
OptionsActuator Only - 240mm Stroke, Kit Form - 240mm Stroke, Compatible JLDQ10.471.272B
Andrew BloodworthJul 10, 2019, 02:46 PMThis item is well worth the money it works very well as a replacement for the Okin Refind -R JLDQ 3A original.
Universal Actuator Measurments
The universal actuators have an overall length of 445mm and a stroke of 240mm. This is industry standard and also has then "0I" power lead plus the 5 pin plug control plug. This overall measurement is from the center of the clevis pin mounting hole to the center of the mounting nut on the opposite end. Please refer to our Data Spec Sheet. The stroke is the distance the white plastic guide travels . This kit also comes with a 1 year warranty.
240mm Actuator Specifications
- Input Voltage:
- 24V DC
- Max Load Capacity:
- Push - 2,500N (250kgs), Pull - 1,500N (150kgs)
- Max Speed:
- Std Stroke:
- MIN Install:
- Limit Switch:
- Type Of Duty:
- S2 - 10mins
- Protection Class:
- CE / EMC+LVD
- Power Wire Plug:
- Standard 0I Plug
- Hand Control Plug:
- Female 5 Pin Plug
Universal Actuator Kit Contains
- x 1
- 0I Extension Cable:
- x 1
- Power Supply:
- x 1
- Power Cable:
- x 1
Removing & Fitting A Actuator
1 Place a drop sheet or old towels around the recliner.
2 Turn off and remove the power supply plug from the mains.
3 Gently turn the recliner over onto its side or on its back. Remember correct lifting methods.
4 Locate the component and its lead. Follow the lead along to the plug ends remembering where it runs.
5 Using a pair of side cutters, snip the cable ties that are retaining the lead to the frame.
6 Loctate the two mounting pins and clips that hold the motor to the frame. Remove the wire retaining clips from the pins using a pair of pointy noise pliars. Hold the motor and remove the pins.
7 Place the new motor assmebly into position. Replace the pins through the mounting holes and attach the wire clips.
8 Plug in all leads and run them along the frame. Check that all leads are out of the way of moving parts. Cable tie the leads back to the frame.
9 Turn the recliner back over to normal seating position
10 Plug the main power supply back into the wall.
11 Test the new component. Operate the lift chair recliner to its fullest position and check that all the leads are clear and not stretched.
12 Return the lift chair to its normal seating position.
DO NOT exceed more then 2 mins operating time at anyone time.
If you do exceed this time, wait 20 mins before using again.