Okin PD13 Power Supply
PD13 Okin Power Supply
CouchGuard® stock the Genuine Okin PD13 Power Supply. This lift chair power supply has the "Ol" flat blade / round pin plug and takes the figure 8 power cord as standard and has provisions for 2 x 9volt batteries - not included. These plug ends are the industry standard and fit 99.9% of the recliners on the market.
You may also use this power supply for the PD12 with the 0l plug. The only difference is the PD12 doesn't have the 9v battery back up
"C" Tick Approved - Meets Australian Standards
$69.00, save $20.00
The 9v battery back up option is generally good for one use only then the batteries need replacing.
Okin PD12 Power Supply 65444 has no battery back up but everything else is the same
OptionsPD13 Power Supply Only with 9v Battery Back Up, PD13 Power Supply Only with 9v Battery Back Up Plus AU Power Lead, PD13 Power Supply Only with 9v Battery Back Up Plus 0I Extension Lead, Complete - PD13 Power Supply 9v Back Up Kit Form, 0I Extension Lead - 1.0 Meter, Figure 8 Lead, Y Splitter
PD13 Power Supply Specifications
- 100 - 240V, 50/60Hz, 1.5amp (Australian figure 8 mains power cord)
- DC 29V = 1.5amp
- STD 01 female ( O l Plug)
- Duty cycle:
- Max 10%; Max Time on: 2 min
Removing & Fitting General Electrical Components
1 Place a drop sheet or old towels around the recliner.
2 Turn off and remove the power supply plug from the mains.
3 Gently turn the recliner over onto its side or on its back. Remember correct lifting methods.
4 Locate the component and its lead. Follow the lead along to the plug end remembering where it runs.
5 Using a pair of side cutters, snip the cable ties that are retaining the lead to the frame.
6 Unplug the socket and remove the old component. Place the new component lead along the same path as the old and cable tie the new lead to the frame.
7 Check all other leads are out of the way of moving parts.
8 Turn the recliner back over to normal seating position
9 Plug the main power supply back into the wall.
10 Test the new component. Operate the lift chair recliner to its fullest position and check that all the leads are clear and not stretched.
11 Return the lift chair to its normal seating position.
DO NOT exceed more then 2 mins operating time at anyone time.
If you do exceed this time, wait 20 mins before using again.