How To Use This Product
CouchGuard® Fitting Directions:
The directions are general instructions and may vary from recliner to recliner.
1 Disconnect any mains power before starting.
2 Using safe lifting methods, disconnect the recliners from the consoles or roll the complete setting over onto its back.
3 Find the wiring for the existing cup holder, follow and disconnect remembering where it goes.
4 Using your fingers, gently lift the cup insert from the cup holder and remove the black foam pad. Remove the 4 screws from the cup holder then remove the cup holder out of the opening.
5 Insert the new cup holder into the opening and position. Fasten with the 4 screws and clip on the top plastic cover.
6 Reconnect the wiring.
7 Switch on the mains power and check to see that LED and or the recliner controls work before putting the recliners and consoles back into postion.
Make sure the fabric or leather hasn't stuck to the old cup holder when removing.
CouchGuard® Plastic and Stainless Steel Cup Holders:
1 Using your fingers, gently pry the cup holder out of the opening.
2 Insert the new cup holder.
3 If your new cup holder has and LED fitted, run the wiring in a safe postion ready for connection.
If the cup holders are jammed tight in the opening you will need to give them a gental tap from the underside to release them. Carefully use your hand or the timber handle end on a hammer.
Warning: Make sure ALL leads are away from moving parts turning on the mains power and before use