Recliner Extension Lead
Two Pin Recliner Extension Cable
CouchGuard® have in stock the electric recliner two pin extension cable with the industry standard "Ol" plug ends which are round pin / flat blade "O l" which fit 99.9% of the recliners on the market. These are the same for both electric lift chairs and electric recliner chairs.
Comes in 3 lengths - 1.2m, 2.4m and 3.5m
The 0l (oh one as it's pronounced) extension lead runs between the power supply and the actuator. It may also plug into the back of the recliner. If this is the case with your recliner, our lead will still fit if you remove the plastic clip.
FAQ's
Q. How do I know my plug is the same size?
A. These plugs are worldwide industry standard O l plugs. One size. When you look at the male plug end it looks like zero (O) and a one ( l ).
Q. Does this lead fit my electric recliner with an Okin actuator?
A. Yes. These plugs are worldwide industry standard O l plugs. One size plug.
Q. I have a Dewert motor in my electric recliner. Will this fit my chair?
A. No. Dewert run a different plug that only they supply.
Removing & Fitting General Electrical Components
1 Place a drop sheet or old towels around the recliner.
2 Turn off and remove the power supply plug from the mains.
3 Gently turn the recliner over onto its side or on its back. Remember correct lifting methods.
4 Locate the component and its lead. Follow the lead along to the plug end remembering where it runs.
5 Using a pair of side cutters, snip the cable ties that are retaining the lead to the frame.
6 Unplug the socket and remove the old component. Place the new component lead along the same path as the old and cable tie the new lead to the frame.
7 Check all other leads are out of the way of moving parts.
8 Turn the recliner back over to normal seating position
9 Plug the main power supply back into the wall.
10 Test the new component. Operate the lift chair recliner to its fullest position and check that all the leads are clear and not stretched.
11 Return the lift chair to its normal seating position.
DO NOT exceed more then 2 mins operating time at anyone time.
If you do exceed this time, wait 20 mins before using again.
