Okin Metal Fork Head
Okin Fork Head
CouchGuard® stock the Okin Deltadrive metal fork head that is found on the Okin motors. The metal fork head is the connector on the end of the stroke tube.
Suitable For the Okin Actuators ONLY which has a 25mm Left Handed Thread. Scroll down for more info.
CouchGuard® is an Australian Owned Company and ALL prices included GST
|1 items||$60.00 / each|
|2-5 items||$54.00 / each||save 10%|
|6-9 items||$51.00 / each||save 15%|
|10 or more items||$48.00 / each||save 20%|
A clevis pin goes through this piece and the chair lift mechanism to hold that end of the motor on the chair. This forkhead will fit the Deltadrive, Gammadrive, Megadrive and Okidrive .
Q. Do these forkheads come with 20mm thread?
A. No. We only stock the Okin style which is 25mm.
- Overall Length:
- Mount Hole:
- Thread Width:
- 25mm left-hand
Compatible with the Okin series motors:
Removing & Fitting A Forkhead
1 Place a drop sheet or old towels around the recliner.
2 Turn off and remove the power supply plug from the mains.
3 Gently turn the recliner over onto its side or on its back. Remember correct lifting methods.
4 Locate the forkhead and remove the clevis pin retainers then the clevis pins. You may choose to only remove the forkhead end pin and replace the forkhead while the actuator is still in the chair.
DO NOT use multi-grips or similar type tools on the very end where the clevis pin hole is. If you really need to use this type of tool then make a firm grip down as close to thew thread as possible.
5 Unwind the old forkhead from the stroke tube. This is a left hand thread then screw in the new one.
6 Reposition the actuator and fit the clevis pins and retainers.
7 Check all leads are out of the way of moving parts.
8 Turn the recliner back over to normal seating position
9 Plug the main power supply back into the wall.
10 Test the new component. Operate the lift chair recliner to its fullest position and check that all the leads are clear and not stretched.
11 Return the lift chair to its normal seating position.
DO NOT exceed more then 2 mins operating time at anyone time.
If you do exceed this time, wait 20 mins before using again.